Floor Coating
CLEANPOXY DHDC-6400(S)
- usage
- Interior dust-proofing floor primer for concrete floors
This paint is a non-solvent-based epoxy paint based on the epoxy-modified amine resin, which can form a strong dry film. It is excellent in adhesion, appearance, durability and chemical resistance, and airless spraying is possible. In particular, since 500㎛-thick coating is possible with one coat, and the smoothness of the film is good, it is a premium non-solvent-based epoxy lining paint that is suitable as a concrete floor paint.
specification
- Paint type
- Modified epoxy / Modified amine (Two-Component)
- Drying time
-
Drying time Category 5℃ 20℃ 30℃ Set-to-touch 10 hours 5 hours 3 hours Dry-through 48 hours 24 hours 18 hours Over-coat (Min.) 72 hours 48 hours 24 hours Over-coat (Max.) 9 days 4 days 3 days Pot life 60 minutes 30 minutes 20 minutes - Thinner
- Not Applicable
- Specific gravity
- Approx. 1.50 (Green)
- Dilution ratio
- ▷No dilution ▷In case of high viscosity in the winter season, dilute within the volume ratio 1%
- Theoretical Coverage
- 0.78 ㎏/㎡ (Based on 0.5 ㎜)
- Solid volume ratio
- 96±3 %
- Color
- Green, gray, other ordered colors
- Thickness of dried film
- 0.5~1 ㎜
- Mixing ratio
- Base(A)/hardener(B)=5/1 (Weight ratio)
- Gloss
- Glossy
- Shelf life
- 6 months
- Packaging unit
- 16L (Compounds)
how to use
- Surface treatment
- 1. Cure concrete for at least 28 days at a temperature of 21℃ and a relative humidity of 50%.
2. Completely remove the oil, moisture, sand, dust, laitance and other foreign matter from the surface and maintain surface smoothness. - Coating method
- 1. Reinforce cracks, crevices, and joints between walls and floors with an epoxy putty after pirmer.
2. Add the hardener to the base and use after evenly mixing for 3-5 minutes with a power stirrer.
3. Apply uniformly with airless equipment.
Appropriate construction specifications
▷Primer : CLEANPOXY CLEAR PRIMER, CLEANPOXY PENETRATE PRIMER DNY-200
▷Lining : CLEANPOXY DHDC-6400(S)
▷Top coat : CLEANPOXY 3100, CLEANPOXY COATING, DHDC-2740(if necessary) - Coating conditions
- 1. Atmosphere Temperature: 5~35℃, Surface Temperature: 40℃ or below, Relative Humidity: 80% or less, Moisture content in the concrete: 6% or less
2. Please note that due to the nature of epoxy paint, discoloration and chalking may occur if exposed to the outdoor environment.
3. Injection pressure : More than 3000 psi(210kgf/㎠)
4. The use of a thinner more than the recommended amount causes a further delay in drying, decline in hardness, whitening, skid marks, etc.