Architecture Paint
MULTI-PLUS WATER-BASED VARNISH
- usage
- Wood Interiors
Multi plus top coat
Oil-based lacquer, enamel old film (interior)
This product is an eco-friendly coating agent suitable for wooden accessories and interior wood finish. It is a air-drying water-based paint composed mainly of fast-drying water-based copolymer special resin and urethane resin, which is made by developing the oil-based vanish into an eco-friendly water-based varnish. It is a highly functional water-based paint that is excellent in dryness, durability, filming forming, and adhesion. Thus, there is no need to worry even if it is applied to old coating of oil-based enamels and lacquers.
specification
- Paint type
- Acrylic / Urethane resin
- Drying time
-
Drying time Category 5℃ 20℃ 30℃ Dry-hard 3~4 hours 2~3 hours 1~2 hours Time required for re-coating (min.) 2 hours - Thinner
- Tap water(dilution rate: less than 5%, volume ratio)
- Coating Method
- Brush, roller, spray coating
- Specific gravity
- Approx. 1.0±0.1
- Solid volume ratio
- Approx. 26 %
- Theoretical Coverage
- 8.7 ㎡/ℓ/2times ※ The application amount may vary depending on basis materials with sever absorption.
- Thickness of dried film
- 30㎛ (2 coats recommended)
- Re-coating interval
- 20℃, sufficient ventilation for a minimum of 2 hours
- Color
- Transparent
- Gloss
- Glossy, semi-gloss, matte
- Storage and preservation
- 12 months (well-ventilated dry, cold and dark location, room temperature 5℃~30℃, humidity less than 80%)
PRODUCT PROPERTIES (PHYSICAL PROPERTY DATA)
- Beautiful appearance
- Imparts a beautiful appearance by smoothing the timber surface.
- Mildew-resistant effect
- It has antibacterial, antiseptic effects.
- Adhesion
- Adhesion to old films of oil-based lacquer and enamel is excellent.
- Environment
- Obtained eco-label certification
how to use
- Surface treatment
- 1. Smooth the rough surface of the substrate by grinding it with sandpaper #180-220 along the grain.
2. Completely clean grease or contaminants and abrasion powder on the surface of the substrate and thoroughly dry it.
3. Thoroughly dry the wet wood and completely remove the mold before coating. - Coating method
- 1. Varnish should be used after slowly stirring to prevent bubbles.
2. Re-coat the varnish after drying for 2 hours after the primary coating. Avoid excessively thick coating upon one coat. (Air bubbles are likely to occur)
3. If the re-coating interval is short, air bubbles may occur during drying after the entire surface coating.